Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Operating and Controlling KIT-400
15
Controlling a Sink Device Via the DATA Ports
Raw data can pass between the DATA ports on the transmitter and receiver ( for KIT-400T
and KIT-400R) directly to/from a controlled device and control system.
Figure 9: Controlling a Sink Device on the Receiver via the Data Ports
Controlling Via Maestro on the Transmitter
You can control the receiver and/or a connected sink device via the KIT-400T Kramer
Maestro.
Controlling the Receiver
To control the receiver via Maestro at the transmitter, send a command via the RS232_HDBT
port in Maestro. For example, to open the relay contacts (RELAY-STATE 1,0), send the
RELAY-STATE 1,0 command from Maestro, via HDBT to the KIT-400R.
Figure 10: Controlling the Receiver via Maestro
13
38