Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Operating and Controlling KIT-400
17
The default OSD timeout is set to 10 seconds.
Use the OSD menu to perform the following operations:
• Adjusting Image Parameters on page 17.
• Selecting an Input Signal on page 18.
• Setting Output Parameters on page 18.
• Setting Audio Parameters on page 19.
• Setting OSD Parameters on page 19.
• Setting HDCP on page 20.
• Setting Sleep Mode on page 20.
• Setting Switching Mode on page 21.
• Setting FREEZE Button Functionality on page 21.
• Managing EDID via OSD on page 21.
• Defining the TOGGLE PIN on KIT-400R on page 22.
• Manually Switching Relay on page 23.
• Defining CEC on page 23.
• Defining Power-up State on page 24.
• Viewing Device Information on page 24.
• Performing a Reset on page 24.
Adjusting Image Parameters
KIT-400R enables adjusting the image parameters such as contrast, brightness and so on.
To adjust the image parameters:
1. On the front panel press MENU. The menu appears.
2. Click Picture and define the image parameters according to the information in the
following table:
Menu Item
Function
Contrast
Set the contrast.
Brightness
Set the brightness.
Finetune
Video
HUE – set the color hue.
SATURATION – set the color saturation.
SHARPNESS – set the sharpness of the picture.
NR (Noise Reduction) – select the noise reduction filter: Off
(default), Low, Middle or High.
Color
Set the Red, Green and Blue shades.
Image parameters are adjusted.