KIT-400 – Operating and Controlling KIT-400
Manually Switching Relay
You can manually set the state of the relay in KIT-400R via the OSD.
To define the relay functionality:
1. On the front panel press MENU. The menu appears.
2. Click Advanced.
3. Click Relay and define its state according to the information in the following table:
Turn the relay ON.
When on, the relay’s coil is energized, meaning C and NO are
shorted, and there is an open circuit between C and NC.
Turn the relay OFF
When off, the relay’s coil is not energized, meaning C and NC are
shorted, and there is an open circuit between C and NO.
Relay is manually switched.
Defining CEC
KIT-400R can be set to initiate and send CEC commands to the connected display, or to pass
CEC commands from its HDMI input to the connected display.
To set the CEC (Consumer Electronic Control) functionality:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Output CEC Bypass.
3. Press ENTER and select:
▪ OFF – KIT-400R automatically sends CEC commands to shut down the output
display after a timeout period when no input signal is found and to power up the
display when the input returns.
▪ ON – CEC commands pass from the HDMI input to the display. (KIT-400R does not
automatically send CEC on and off commands).
KIT-400R either passes CEC commands between its HDMI input and the display, or it
initiates and sends on and off commands to the display.
To Next Page
Loading...
