Enabling Audio Only
KIT-400T enables passing only the audio signal via the embedded webpages.
To enable/disable audio only:
1. In the Navigation pane, click Video & Audio Settings. The Video & Audio Settings page
appears (see Figure 27).
2. Click Enabled to enable audio only; and click Disabled for AV switching.
Audio only mode is set.
Setting HDCP Support
Enable or disable HDCP support for the HDMI inputs on the KIT-400T.
To enable/disable HDCP support on the HDMI inputs:
1. In the Navigation pane, click Video & Audio Settings. The Video & Audio page appears
(see Figure 27).
2. for each local HDMI input, Click Enabled to enable HDCP support or Disabled to
disable HDCP support.
HDCP support is set.
Setting Audio and Video Timeouts
KIT-400T enables setting the video and audio timeout settings via the embedded webpages.
To set the video / audio timeouts:
1. In the Navigation pane, click Video and Audio Settings. The Video & Audio Settings
page appears (see Figure 27).
2. Set the timeout in seconds for delaying:
▪ Switching upon signal loss when 5V power is left on.
▪ Switching in case a cable is unplugged.
3. Click Set Timeout.
Video and audio timeouts are set.
To Next Page
Loading...
