KIT-400 – Using Embedded Webpages
2. Click Triggers. The Triggers area opens. The Triggers area lists 5 default triggers.
Figure 30: [Figure Caption]
3. Select Last Off trigger.
4. In the Trigger area, next to Script to run, click Disabled.
5. Repeat the last 2 steps for the next three triggers:
▪ Port Connectivity 1.
▪ Port Connectivity 2.
▪ Port Connectivity 3.
6. Click Save All.
We recommend keeping the Power On trigger.
7. On the KIT-400T rear panel, set both video DIP-switches 1 and 2 to ON (down),
(see Setting KIT-400T DIP-switches on page 13).
8. Power-cycle the device.
Auto-switching is disabled.
To Next Page
Loading...
