Kramer KIT-400 - Page 82

Kramer Electronics Ltd.
KIT-400 – Protocol 3000
80
Function
Description
Syntax
Parameters/Attributes
Example
LOGIN
Set protocol
permission.
The permission
system works only if
security is enabled with
the “SECUR”
command.
LOGIN allows the user
to run commands with
an End User or
Administrator
permission level.
When the permission
system is enabled,
LOGIN enables running
commands with the
User or Administrator
permission level
When set, login must
be performed upon
each connection
It is not mandatory to
enable the permission
system in order to use
the device
In each device, some
connections allow
logging in to different
levels. Some do not
work with security at all.
Connection may logout
after timeout.
COMMAND
#LOGINlogin_level,password<CR>
FEEDBACK
~nn@LOGINlogin_level,passwordok<CR><LF>
or
~nn@LOGINerr004<CR><LF>
(if bad password entered)
login_level – Level of
permissions required (User or
Admin)
password – Predefined password
(by PASS command). Default
password is an empty string
Set the protocol permission
level to Admin (when the
password defined in the
PASS command is 33333):
#LOGINadmin,33333<CR
>
LOGIN?
Get current protocol
permission level.
The permission
system works only if
security is enabled with
the “SECUR”
command.
For devices that
support security,
LOGIN allows the user
to run commands with
an End User or
Administrator
permission level.
In each device, some
connections allow
logging in to different
levels. Some do not
work with security at all.
Connection may logout
after timeout.
COMMAND
#LOGIN?<CR>
FEEDBACK
~nn@LOGINlogin_level<CR><LF>
login_level – Level of
permissions required (User or
Admin)
Get current protocol
permission level:
#LOGIN?<CR>
LOGOUT
Cancel current
permission level.
Logs out from End
User or Administrator
permission levels to Not
Secure.
COMMAND
#LOGOUT<CR>
FEEDBACK
~nn@LOGOUTok<CR><LF>
#LOGOUT<CR>
MODEL?
Get device model.
This command
identifies equipment
connected to KIT-400
and notifies of identity
changes to the
connected equipment.
The Matrix saves this
data in memory to
answer REMOTE-INFO
requests.
COMMAND
#MODEL?<CR>
FEEDBACK
~nn@MODELmodel_name<CR><LF>
model_name – String of up to 19
printable ASCII chars
Get the device model:
#MODEL?<CR>
MUTE
Set audio mute.
COMMAND
#MUTEout_index,mute_mode<CR>
FEEDBACK
~nn@MUTEout_index,mute_mode<CR><LF>
out_index – Number that
indicates the specific output:
1 – AUDIO OUT
mute_mode – On/Off
0 – Off
1 – On
Set Output 1 to mute:
#MUTE1,1<CR>
MUTE?
Get audio mute.
COMMAND
#MUTE?out_index<CR>
FEEDBACK
~nn@MUTEout_index,mute_mode<CR><LF>
out_index – Number that
indicates the specific output:
1 – AUDIO OUT
mute_mode – On/Off
0 – Off
1 – On
Get mute status of output 1
#MUTE1?<CR>