Kramer VS-1616A

Viewing the MENU Commands Sequence
43
43
2. Press the TAKE button.
The Displays show the messages:
OUTkey 1: Stand-Alone UNIT
2: Large Matrix
Current
Matrix
3. Press the OUT button # 2.
The Displays show the messages:
set NEW matrix
new -> TAKE leave old -> MENU
current:
16x32
4. Press the TAKE button again.
The Displays show the messages:
READY to set MACHINE ADDRESS
use OUTkey 1-9, 0
current #
1
5. Press an OUT button # 1-9, 0.
The STATUS Display shows the message:
current: x
Where x is the OUT button # pressed
6. Press the TAKE button again.
The TAKE LED blinks and the Displays show the messages:
READY to change MACH. ADDR.
Press TAKE to confirm
from # 01
to #0x
7. Press the TAKE button again.
The Displays show the messages:
MACHINE ADDRESS
changed
current #
x
After a few seconds, the Displays show the messages:
SET highest MACHINE ADDRESS
use OUTkey 1-9, 0
current #
x
8. Press an OUT button # 1-9, 0.
The STATUS Display shows the message:
current:
x
Where x is the OUT button # pressed
9. Press the TAKE button again.
The MATRIX Display shows the message:
Change highest MACH. ADDR. ?
Press TAKE to confirm