Mounting VW-16
This section provides instructions for mounting VW-16. Before you start the installation, make
sure that the environment is within the recommended range:
• Operation temperature – 0 to 40C (32 to 104F).
• Storage temperature – -20 to +60C (-4 to +140F).
• Humidity – 0% to 80%, RH.
Caution:
• Mount VW-16 before connecting any cables or power.
Warning:
• Ensure that the environment, such as maximum ambient temperature & air flow, is
compatible for the device.
• Prevent uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings must be used to prevent
circuit overload.
• Reliable earthing of rack-mounted equipment must be maintained.
• Use the recommended rack adapter
(see www.kramerav.com/product/VW-16).
Mount VW-16 on a surface using one of these methods:
• Attach the rubber feet and place the unit on a flat surface.
• Attach both rack ears (remove the screws from each side of the
machine and replace those screws through the rack ears). For
more information, go to www.kramerav.com/downloads/VW-16.
To Next Page
Loading...
Need help?
General
