Krone EasyCut 320 - Mounting Onto the Tractor; Clutching Points

Commissioning
27
Pos: 15.9 /Überschriften/Überschriften 2/A-E/AAnbau an den Traktor @ 0\mod_1199717845194_78.docx @ 34039 @ 2 @ 1
5.3 Mounting onto the Tractor
Pos: 15.10 /Überschriften/Überschriften 3/K-O/KKuppelpunkte @ 9\mod_1220531326398_78.docx @ 126608 @ 3 @ 1
5.3.1 Clutching points
Pos: 15.11 /BA/Erstinbetriebnahme/EasyCut/Kuppelpunkte/Kuppelpunkte Bild EC 280/320 @ 9\mod_1220535044008_78.docx @ 126793 @ @ 1
I II
X
X
POS.1
POS.1
1
POS.2
POS.2
1
X
X
EC-0-214
Figure.
4
Pos: 15.12 /BA/Erstinbetriebnahme/EasyCut/Kuppelpunkte/Kuppelpunkte Text EC 280/320 @ 9\mod_1220535134976_78.docx @ 126814 @ @ 1
There are 2 possibilities for attaching the mowing unit.
I)
The steerable pinions are designed according to cat. II. Normally, the mowing unit is hooked to
the tractor in pos. 1. When using broad tractors or when working in combination with front
mowing units (working width of approx. 2.8 - 3.2 m), the mowing unit should be attached at pos.
2.
II)
In addition, the steerable pinions (1) in pos.1 and pos. 2 can be adjusted by X = 50 mm.
Pos: 15.13 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1