Krone EasyCut 320 - Oil Level Check and Oil Change on the Cutter Bar; Oil Change; Checking the Oil Level

Maintenance
54
Pos: 25.24.1 /Überschriften/Überschriften 2/K-O/OÖlstandskontrolle und Ölwechsel am Mähholm @ 0\mod_1197017549815_78.docx @ 15963 @ 2 @ 1
10.7 Oil level check and oil change on the cutter bar
Pos: 25.24.2 /Überschriften/Überschriften 3/K-O/OÖlwechsel @ 0\mod_1197021941955_78.docx @ 16139 @ 3 @ 1
10.7.1 Oil change
Pos: 25.24.3 /BA/Wartung/Mähwerke/Hinweis Ein Ölwechsel am Mähholm ist nicht erforderlich. @ 68\mod_1304577391388_78.docx @ 628708 @ @ 1
Note
No oil change is required on the cutter bar.
Pos: 25.24.4 /Überschriften/Überschriften 3/K-O/OÖlkontrolle @ 0\mod_1197021908190_78.docx @ 16120 @ 3 @ 1
10.7.2 Checking the oil level
Pos: 25.24.5 /BA/Sicherheit/7. Gefahrenhinweise alt/Mähwerke/Gefahr - Schnell rotierende Messerteller/Messertrommel_2 @ 0\mod_1197022569252_78.docx @ 16165 @ @ 1
Danger! - Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
Lower guards. Nobody should be in the danger zone around the machine.
Pos: 25.24.6 /BA/Sicherheit/7. Gefahrenhinweise alt/Mähwerke/Gefahr - Schnell rotierende Messerteller/Messertrommeln_1 @ 0\mod_1197017696736_78.docx @ 16001 @ @ 1
Danger! - Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
• Switch off the engine and remove the ignition key.
• The cutting discs/blade drums continue to run!
• Do not leave the driver’s cab until the cutting discs/blade drums have come to a complete
stop.
Pos: 25.24.7 /BA/Wartung/Mähwerke/Ölkontrolle Mähholm Easycut EC 280/320 @ 9\mod_1221047992481_78.docx @ 131607 @ @ 1
EC-0-003
Fig.
24
• Allow the machine to run briefly.
• Wait until cutting discs/blade drums have come to a complete stop.
• Move the cutter bar into transport position.
Check the oil level before every use
• Remove the oil level inspection screw (1) from the cutter bar.
• The oil level must be up to the bore hole. If required, top up the oil (SAE 90)
• Screw in the oil level inspection screw (1) again and tighten securely.
Pos: 25.25 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1