Krone EasyCut 320 - Settings; Cutting Height and Compensation Springs

Settings
45
Pos: 23.1 /Überschriften/Überschriften 1/A-E/Einstellungen @ 0\mod_1199868783862_78.docx @ 36141 @ 1 @ 1
9 Settings
Pos: 23.2 /BA/Sicherheit/7. Gefahrenhinweise alt/Mähwerke/Warnung - Einstellarbeiten angebaute Maschinen @ 254\mod_1397487875458_78.docx @ 1953794 @ @ 1
DANGER! - Unexpected movement of the machine
Effect: Danger to life or serious injuries.
• Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill!
• Switch off engine.
• Remove the ignition key and carry it with you.
• Secure the tractor against rolling away.
Pos: 23.3 /Überschriften/Überschriften 2/A-E/EEinstellen der Schnitthöhe @ 0\mod_1196660879619_78.docx @ 9191 @ 2 @ 1
9.1 Adjusting the cutting height
Pos: 23.4 /BA/Einstellungen/Mähwerke/Schnitthöhe/Schnitthöhe Bild EC 280/320 @ 9\mod_1220960163568_78.docx @ 130227 @ @ 1
Figure
19
Pos: 23.5 /BA/Einstellungen/Mähwerke/Schnitthöhe/Schnitthöhe größer_geringer EC280/320 @ 9\mod_1220960304209_78.docx @ 130271 @ @ 1
The cutting height is adjusted via the top link (1).
To do this:
• Swivel the parking support(s) down
• Lower the machine into working position and set it down on the parking support(s).
• Rotate the top suspension arm (1).
• Fold in the parking support(s).
Top suspension arm longer = bigger cutting height
Top suspension arm shorter = smaller cutting height
Pos: 23.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1