Krone EasyCut 320 - Tightening Torques and Lubrication

Maintenance
49
Pos: 25.8 /Überschriften/Überschriften 2/A-E/EErsatzteile @ 0\mod_1196782991234_78.docx @ 14927 @ 2 @ 1
10.2 Spare Parts
Pos: 25.9 /BA/Sicherheit/7. Gefahrenhinweise alt/Mähwerke/WARNUNG - Verwendung von nicht zugelassenen Ersatzteilen @ 308\mod_1417011577394_78.docx @ 2392925 @ @ 1
Warning! - Using non-approved spare parts.
Effect: Danger to life, serious injuries or loss of warranty claims as well as exclusion of liability
• Use only authentic KRONE spare parts and accessories authorised by the manufacturer.
The use of spare parts, accessories or additional equipment not manufactured, tested or
approved by KRONE will exclude any liability for consequential damage.
Pos: 25.10.1 /Überschriften/Überschriften 2/A-E/AAnziehdrehmomente @ 202\mod_1385711894606_78.docx @ 1693123 @ 2 @ 1
10.3 Tightening torques
Pos: 25.10.2 /Überschriften/Überschriften 3/K-O/MMetrische Gewindeschrauben mit Regelgewinde @ 322\mod_1424945442462_78.docx @ 2483466 @ 3 @ 1
10.3.1 Metric Thread Screws with Control Thread
Pos: 25.10.3 /BA/Wartung/Drehmomente / Anziehdrehmomente/Anziehdrehmomente Metrische Gewindeschrauben mit Regelgewinde Tabelle @ 321\mod_1424760222607_78.docx @ 2477725 @ @ 1
NOTICE
The table does not apply to countersunk screws with hexagonal socket in case the countersunk
screw is tightened via hexagonal socket.
Tightening torque in Nm (unless
otherwise stated)
A = thread size
(stability class can be seen on screw head)
A
Stability class
5.6
8.8
10.9
12.9
Tightening torque (Nm)
M4
3.0
4.4
5.1
M5
5.9
8.7
10
M6
10
15
18
M8
25
36
43
M10
29
49
72
84
M12
42
85
125
145
M14
135
200
235
M16
210
310
365
M20
425
610
710
M22
571
832
972
M24
730
1050
1220
M27
1100
1550
1800
M30
1450
2100
2450
Pos: 25.10.4 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1