Krone EasyCut 320 - Pole Protection Mechanism

Settings
47
Pos: 23.14 /Überschriften/Überschriften 2/A-E/EEinstellung der Pfahlsicherung @ 9\mod_1220961168693_78.docx @ 130388 @ 2 @ 1
9.3 Setting of the pole protection mechanism
Pos: 23.15 /BA/Sicherheit/EasyCut/Achtung - Einstellung an der Pfahlsicherung @ 9\mod_1220960955600_78.docx @ 130367 @ @ 1
Caution! - Adjusting the pole protection mechanism
Effect: Damage to the machine
• If the setting value is changed, the trigger moment will also change. If the spring on the
pole protection mechanism is pretensioned more than prescribed by the manufacturer,
there is a risk of damaging the disc mower.
• The spring on the pole protection mechanism must be tensioned at least to the extent that
the pole protection mechanism does not respond in transport position even with abrupt
loads.
Pos: 23.16 /BA/Einstellungen/Mähwerke/EasyCut/Pfahlsicherung/Pfahlsicherung Bild @ 9\mod_1220961709850_78.docx @ 130512 @ @ 1
Figure
21
Pos: 23.17 /BA/Einstellungen/Mähwerke/EasyCut/Pfahlsicherung/Pfahlsicherung allgemein @ 9\mod_1220961293021_78.docx @ 130429 @ @ 1
In order to protect the disc mower against damages during driving over obstacles, it is equipped
with a so-called pole protection mechanism.
The optimal setting for the trigger moment takes place in the factory.
Pos: 23.18 /BA/Einstellungen/Mähwerke/EasyCut/Pfahlsicherung/Pfahlsicherung EC 280/320 Tabelle @ 9\mod_1220961422006_78.docx @ 130450 @ @ 1
Mower type
Dimension x
EASYCUT 280
83 mm
EASYCUT 320
83 mm
Pos: 23.19 /BA/Einstellungen/Mähwerke/EasyCut/Pfahlsicherung/Pfahlsicherung nach dem Auslösen @ 9\mod_1220961640381_78.docx @ 130471 @ @ 1
After the pole protection mechanism is triggered, the mowing unit swings back and, at the same
time, in the front area upwards. This allows the mower to climb over small obstacles, e.g.,
stones. The pole protection mechanism will catch again as soon as you move back.
Pos: 24 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1