12 EC Declarations of Conformity
45 of 50
KSB Guard
12 EC Declarations of Conformity
12.1 EU Declaration of Conformity
Manufacturer: KSB SE & Co. KGaA
Johann-Klein-Straße 9
67227 Frankenthal (Germany)
This EU Declaration of Conformity is issued under the sole responsibility of the manufacturer.
The manufacturer herewith declares that the products::
KSB Guard ATEX sensor unit: Ident. number 05088764
KSB Guard ATEX transmission and battery
unit:
Ident. number 05088765
KSB Guard ATEX kit: Ident. number 05088763
▪ are in conformity with the provisions of the following Directives as amended from time to time:
– 2014/34/EU: Equipment and protective systems intended for use in potentially explosive atmospheres
(ATEX)
– 2014/53/EU: Radio Equipment Directive (RED)
– 2011/65/EU: Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
(RoHS)
▪ the following harmonised international standards have been applied:
– EN IEC 60079-0:2018
– EN 60079-11:2012
– ETSI EN 301 489-17 V3.2.4
– ETSI EN 301 489-1 V2.2.3
– ETSI EN 300 328 V2.2.2
– EN 61000-6-3:2007 + A1:2011
– EN 61000-6-2:2005
– EN 61000-6-2:2019
– EN 62311:2020
In compliance with Directive 2014/34/EU, the product is marked as follows: II 2G Ex ib IIC T4 Gb
The EU type test certificate DEKRA 20ATEX0140X is available for this device.
The manufacturer's quality assurance system is monitored by 0035 TÜV Rheinland Industrie Service GmbH.
The EU Declaration of Conformity was issued in/on:
Frankenthal, 1 March 2021
Thomas Paulus
Corporate Function Digital Global Executive Officer - CDO
KSB SE & Co. KGaA
Johann-Klein-Straße 9
67227 Frankenthal
To Next Page
Loading...
