KSB Hya-Solo DSV Series User Manual

7 Commissioning/Start-up/Shutdown
21 of 44
Hya-Solo DSV
7.3 Checklist for commissioning/start-up
Table7: Checklist
Operations Done
1 Read the operating instructions.
2 Check power supply and compare against the name plate data.
3 Check the earthing system (by measuring).
4 Check the mechanical connection to the water mains.
Re-tighten the flange bolting and pipe unions.
5 Prime and vent the pressure booster system from the inlet side.
6 Check inlet pressure.
7 Check whether all cables are still firmly connected to the terminals inside the control unit.
8 Check the setpoint, re-adjust if necessary.
9 Test the proper function of the lack-of-water and dry running protection equipment. If not
fitted, make a relevant note in the commissioning report.
10 Vent the pump for a second time after it has been running for 5 to 10 minutes.
11 Check the pre-charge pressure.
12 Record all system conditions that do not correspond to our specifications or to the purchase
order in the commissioning report (i.e. no dry running protection or inlet pressure + max.
pressure of pressure booster system higher than 16 bar).
13 Complete the commissioning report together with the operator/user and instruct the operator/
user as to the function of the system.
7.4 Shutdown
NOTE
As long as the pressure booster system is out of operation, water is supplied directly
at p
inl
through the pressure booster system.
Set the master switch to "0".
NOTE
Drain the pressure booster system for prolonged shutdown.

KSB Hya-Solo DSV Series Specifications

General

Brand	KSB
Model	Hya-Solo DSV Series
Category	Water Pump
Language	English