4 Transport/Temporary Storage/Disposal
9 of 44
Hya-Solo DSV
4 Transport/Temporary Storage/Disposal
4.1 Checking the condition upon delivery
1. On transfer of goods, check each packaging unit for damage.
2. In the event of in-transit damage, assess the exact damage, document it and
notify KSB or the supplying dealer and the insurer about the damage in writing
immediately.
4.2 Transport
NOTE
The pressure booster system is bolted to a pallet and wrapped in plastic foil for
shipping and temporary storage. All connecting points are capped.
DANGER
Pressure booster system tipping over
Risk of injury by falling pressure booster system!
▷ Never suspend the pressure booster system by its power cable.
▷ Observe the applicable local accident prevention regulations.
▷ Pay attention to the weight data and the centre of gravity.
▷ Use suitable and permitted transporting equipment, e.g. crane, forklift or
elevating platform truck.
▷ Attach the pressure booster system to crane lifting tackle as shown, or use a
forklift or pallet truck to move the pallet.
Fig.1: Transporting the pressure booster system
ü The pressure booster system has been checked for in-transit damage.
1. Make sure the transport equipment is suitable for safely carrying the indicated
load.
2. Transport the pressure booster system to the place of installation.
3. Attach the pressure booster system to the lifting tackle as shown, lift it off the
pallet and dispose of the pallet.
4. Use suitable lifting equipment to lift the pressure booster system and carefully
put it down at the place of installation.
4.3 Storage/preservation
If commissioning is to take place some time after delivery, we recommend that the
following measures be taken when storing the pressure booster system:
To Next Page
Loading...
Need help?
General
