KTM 65 SX - Service Work on the Chassis; Raising the Motorcycle with a Lift Stand; Removing the Motorcycle from the Lift Stand

11 SERVICE WORK ON THE CHASSIS 27
11.1 Raising the motorcycle with a lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
601945-01
– Raise the motorcycle at the frame underneath the engine.
Lift stand (59229055000)
The tires should no longer be in contact with the ground.
– Secure the motorcycle against falling over.
11.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
602658-10
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
– To park the motorcycle, insert plug-in stand 1 into the plug-in stand bracket on
the left side of the vehicle.
Info
Remove the plug-in stand before riding.
11.3 Bleeding fork legs
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 27)
C00007-10
Main work
– Remove bleeder screws 1 briefly.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten bleeder screws.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 27)