KTM 890 ADVENTURE R 2023 - Removing the Left Side Cover

13 SERVICE WORK ON THE CHASSIS
100
V01265-10
– Check the chain sliding guard for wear.
» If continuous signs of wear to the chain are visible on the
chain sliding guard in the area
D
marked:
– Change the chain sliding guard.
» If the chain sliding guard is highly worn on the underside
in the marked area
E
:
– Change the chain sliding guard.
– Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
– Tighten screws on the chain sliding guard.
Guideline
Remaining screws,
chassis
M5 5 Nm (3.7 lbf ft)
Finishing work
– Remove the rear of the motorcycle from the lifting gear.
( p. 94)
13.12 Removing the left side cover
Preparatory work
– Remove the seat. ( p. 95)
F03293-10
Main work
– Remove left side cover from the rubber bushings in the
areas
A
and
B
.
– Pull off the left side cover sideways and remove it toward the
front.