ELECTRICAL SYSTEM 16
133
F03301-10
–
Hang battery mounting bracket
4
to the left and right in the
holding lugs and push downward at the back.
–
Mount and tighten screw
5
.
Guideline
Screw, battery hold-
ing bracket
M6 4.5 Nm
(3.32 lbf ft)
–
Position the diagnostics connector
6
in the holder.
Finishing work
– Install the battery cover. ( p. 103)
– Mount the seat. ( p. 95)
– Set time and date.
16.4 Charging the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V battery.
–
Only charge 12 V batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
– Do not dispose of 12 V batteries as household waste.
– Dispose of 12 V batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
To Next Page
Loading...
