11 SERVICE WORK ON THE CHASSIS
72
Main work
– Check the throttle cable routing. ( p. 78)
F01541-11
– Position the fuel tank and fit the two spoilers to the sides of
the radiator bracket.
– Make sure that no cables or throttle cables are trapped or dam-
aged.
– Attach the hose to the fuel tank breather on the tank lid.
–
Mount and tighten screws
1
with the collar bushings.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
K01034-11
(All SX‑F models)
–
Mount and tighten screw
2
with the rubber bushing.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
F01591-11
–
Plug in connector
3
for the fuel pump.
– Remove the wash cap set. Thoroughly clean the plug-in
connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the
fuel line. Dirt in the fuel line clogs the injection
valve!
–
Lubricate the O-ring and connect plug-in connection
4
for the fuel line.
Info
Route the cable and fuel line at a safe distance
from the exhaust system.
F01565-11
(XC‑F US)
–
Mount and tighten screw
2
with the rubber bushing.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
To Next Page
Loading...
