17 POWERPACK HV, BATTERY CHARGER
114
Info
The charging procedure is identical regardless of whether the Powerpack HV is charged while installed
in the vehicle or having been removed. However, the 12‑V battery is only charged if the Powerpack HV is
being charged in the vehicle.
Charge the Powerpack HV regularly inside the vehicle in order to charge the 12-V battery as well.
Do not activate the vehicle while the battery charger is connected to the Powerpack HV.
If the vehicle is activated while the vehicle is being charged with the Powerpack HV installed, the vehicle
switches to the error state. The Powerpack HV will continue to be recharged; however, the 12-V battery
will stop recharging.
Info
When the left LED in the charging level indicator on the battery charger flashes, the PowerPack HV is
ready for use. However, full capacity is not yet available.
To guarantee the maximum capacity of the Powerpack HV, discharge the Powerpack HV completely every
20 charging cycles and then recharge it completely. If this process is not carried out, then the vehicle may
switch off due to a charging level which is too low without reducing power beforehand.
The Powerpack HV is completely discharged when the vehicle switches off with blink code 11.
Info
If the temperature of the Powerpack HV exceeds the permissible value while it is being charged, the bat-
tery charger stops charging. All LEDs and the LEDS for the current charging level alternately light up every
second.
After the temperature of the Powerpack HV returns to the permissible range, charging is resumed automat-
ically.
Preparatory work
– Position the battery charger. ( p. 111)
(Option: Battery charger 1)
– Check residual current protection switch. ( p. 113)
– Push the main switch into position .
– Fold the seat up. ( p. 69)
C00815-10
Main work
–
Remove charging socket protection cap
1
.
Warning
Risk of injury The intrinsic safety of the Powerpack
HV can only be guaranteed if the original battery
charger is used.
The Powerpack HV may only be charged with the orig-
inal battery charger.
– Only use the original battery charger to charge the
Powerpack HV.
– Connect the battery charger to the Powerpack HV. Observe
plug marking
A
.
To Next Page
Loading...
