KTM Freeride E-XC 2021 - Removing the Rear Wheel

15 WHEELS, TIRES
92
H00935-10
Main work
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact surfaces
A
of the spacers.
Long-life grease ( p. 145)
– Insert the spacers.
F03137-11
–
Clean and grease the wheel spindle.
Long-life grease ( p. 145)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M20x1.5 35 Nm (25.8 lbf ft)
– Operate the front brake lever several times until the brake lin-
ings are in contact with the brake disc.
– Remove the motorcycle from the lift stand. ( p. 57)
– Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
3
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
Finishing work
– Install the Powerpack HV. ( p. 109)
– Lock the seat. ( p. 69)
15.3 Removing the rear wheel
Preparatory work
– Deactivate the vehicle. ( p. 43)
– Fold the seat up. ( p. 69)
– Remove the Powerpack HV. ( p. 108)
– Mount the protection cap. ( p. 71)
– Raise the motorcycle with a lift stand. ( p. 57)