KTM Freeride E-XC 2021 - Greasing the Steering Head Bearing; Removing Front Fender

13 SERVICE WORK ON THE CHASSIS
66
Guideline
Screw, top triple
clamp
M8 22 Nm (16.2 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top
steering stem
M8 17 Nm (12.5 lbf ft)
Loctite
®
243™
Finishing work
– Check steering head bearing play. ( p. 64)
– Remove the motorcycle from the lift stand. ( p. 57)
– Install the Powerpack HV. ( p. 109)
– Lock the seat. ( p. 69)
13.13 Greasing the steering head bearing
H02387-01
– Remove the lower triple clamp. ( p. 61)
– Install the lower triple clamp. ( p. 62)
13.14 Removing front fender
Preparatory work
– Deactivate the vehicle. ( p. 43)
– Fold the seat up. ( p. 69)
– Remove the Powerpack HV. ( p. 108)
– Mount the protection cap. ( p. 71)
– Remove the headlight mask with the headlight. ( p. 102)