KTM Freeride E-XC 2021 - Mounting the Protection Cap; Removing the Protection Cap; Checking the Battery Discharge Plug Form Ring

SERVICE WORK ON THE CHASSIS 13
71
13.22 Mounting the protection cap
Note
Material damage Components damaged or destroyed by water or dirt.
– Mount the protection cap after you have removed the Powerpack HV.
Preparatory work
– Deactivate the vehicle. ( p. 43)
– Fold the seat up. ( p. 69)
– Remove the Powerpack HV. ( p. 108)
F01672-10
Main work
– Check the battery discharge plug form ring. ( p. 71)
–
Mount protection cap
1
with one hand.
13.23 Removing the protection cap
Note
Material damage Components damaged or destroyed by water or dirt.
– Mount the protection cap after you have removed the Powerpack HV.
F01672-10
Main work
–
Remove protection cap
1
with one hand.
Finishing work
– Install the Powerpack HV. ( p. 109)
– Lock the seat. ( p. 69)
13.24 Checking the battery discharge plug form ring
Condition
The Powerpack HV is removed.
The protection cap has been removed.