EasyManua.ls Logo

KTM Freeride E-XC 2021 - Page 89

KTM Freeride E-XC 2021
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BRAKE SYSTEM 14
87
Warning
Skin irritationBrake fluid causes skin irritation.
Keep brake fluid out of the reach of children.
Wear suitable protective clothing and safety glasses.
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
Consult a doctor immediately if brake fluid has been swallowed.
Rinse the affected area with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
If brake fluid spills on to your clothing, change the clothing.
Warning
Danger of accidentsOld brake fluid reduces the braking effect.
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidentsUnsuitable brake fluid damages the brake system.
DOT 5 brake fluid attacks seals and brake lines. DOT 5 brake fluid is silicone-based and purple in color.
Do not use DOT 5 brake fluid.
Note
Environmental hazardHazardous substances cause environmental damage.
Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applica-
ble regulations.
Info
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
Preparatory work
Deactivate the vehicle. ( p. 43)
Fold the seat up. ( p. 69)
Remove the Powerpack HV. ( p. 108)
Mount the protection cap. ( p. 71)
Check the rear brake linings. ( p. 88)
F03134-10
Main work
Move the brake fluid reservoir attached to the left of the han-
dlebar to a horizontal position.
Remove screws
1
.
Take off cover
2
with membrane
3
.
Add brake fluid to level
A
.
Guideline
Level
A
(brake fluid level
below reservoir rim)
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 143)
Position the cover with the membrane. Mount and tighten the
screws.

Table of Contents

Related product manuals