KTM RC 200 - Adding Engine Oil

18 SERVICE WORK ON THE ENGINE 161
Info
Drain the engine oil only when the engine is warm.
Preparatory work
– Remove the right side cover. ( p. 103)
– Remove the left side cover. ( p. 100)
– Remove the front spoiler. ( p. 96)
– Stand the motorcycle on its side stand on a horizontal surface.
L02168-10
Main work
– Place a suitable container under the engine.
–
Remove oil drain plug

with the O-ring.
–
Remove oil screen

with the O-ring.
– Completely drain the engine oil.
– Clean the oil drain plug and oil screen thoroughly.
–
Position oil screen

and mount and tighten oil drain plug

with the O-ring.
Guideline
Oil drain plug (RC 125) M24x1.5 15 Nm
(11.1 lbf ft)
Oil drain plug (RC 200) M24x1.5 15 Nm
(11.1 lbf ft)