SAFE OPERATION-4
Before leaving the machine,
A Park the excavator on a firm, flat and level surface.
A Lower the attachments and the dozer blade to the
ground.
A Stop the engine.
A Release pressure trapped in the hydraulic system.
A Lock all control levers.
A Remove the key.
1. Observe all regulations concerning the transport of
excavators on public roads.
2. Use adequately long and robust ramps when loading
on the machine. (for details see "TRANSPORTING
THE EXCAVATOR ON A VEHICLE")
3. Do not change the running direction and to avoid a
tipping over, do not try to swing the attachment
crosswise to the loading ramps.
4. Lower the attachment on the loading bed and release
the pressure from the hydraulic system.
After loading the excavator on the truck, block the
tracks with blocks and tie down the excavator.
5. Avoid abrupt braking of the vehicle with the excavator
loaded. Sudden braking cause the excavator to move
and may cause a serious accident.
6. If the excavator is to tow another machine, make sure
the load is smaller than the strength of the hook, tow
chain or cable.
3. AFTER OPERATION
(1) Lock lever for control lever (A) "Unlock"
(B) "Lock"
4. SAFE LOADING AND TRANSPORT OF
THE EXCAVATOR
(1) Wire rope
(2) Block
(1) Hook
To Next Page
Loading...
