CHECKS BEFORE START8
BWorking Light Switch
When the starter switch is in position "RUN", the light(s)
will be switched on by pressing the switch.
C Night operation
To avoid personal injury:
A Visibility is reduced in darkness, therefore the
working light alone may not be enough. In
which case, prepare additional stationary
artificial lighting, observe safety rules as well
as special regulations for night work.
BOpening/Closing of CAB Door
1. Unlock the CAB door and pull the knob. Open the CAB
door fully until fixed into place.
2. To close the CAB door, push the release lever down
and close the door.
3. When leaving the excavator, always lock the door.
(1) Working light switch
(1) Door knob (outside)
(1) Release lever
(1) Door knob(inside)
(A) Push down
To Next Page
Loading...
