CHECKS BEFORE START10
BLCD Display for Warning
C Remaining fuel warning
When the fuel level is very low, the lamp (yellow) starts
flashing and the following message appears in the
display.
A After a short period of time, the display comes back to
normal.
A After a short period of time, the message shows up
again.
A Even while in the normal display mode, the warning
lamp keeps on blinking.
A To see what warning is being given out, press the
display selector switch. The current warning can then
be identified.
C Battery charge warning
If the starter key is turned to the "RUN" position without
starting the engine, and the charging lamp stays off, the
charging system has failed. If such occurs, immediately
contact your local dealer for repair.
C Engine oil pressure low warning
When the engine oil pressure drops too low, the lamp
(red) starts flashing and the following message appears in
the display.
Immediately stop the engine and check the engine oil
level.
A If the starter key is turned to the "RUN" position
without running the engine and the oil lamp stays off,
then the hydraulic system may have failed.
If such occurs, immediately contact your local dealer
for repair.
C Various error warnings
If any components are detected to be in trouble, the
following message appears onscreen.
(See "LIST OF SCREENS" section)
(1) Charging lamp
(1) Oil lamp
To Next Page
Loading...
