47EXCAVATOR OPERATION
BHow to Resume the AUX Setting While
Processing the DPF Regeneration
When the automatic regeneration process of DPF gets
started with the AUX port in use, the warning (A) is
displayed on the LCD display. The indicator (B) turns off,
however, the operator can keep to use the AUX port
function. To resume the AUX port settings while the
warning is displayed, follow the procedure.
1. The indicator turns off, and the warning appears on the
LCD display.
2. Press the switch 5.
3. The warning disappears temporarily and the normal
display shows up again.
4. Press the switch 3 to continue to set the AUX settings
as usual.
Even when the warning temporarily disappears according
to the above procedure, however, the warning reappears
in a certain period of time during the automatic
regeneration.
A While a warning message like as “Raise up engine
speed.” is on the LCD display, operator is requested to
take directive procedure and take above procedure if
operator require to continue to set AUX setting.
HOW TO RELEASE PRESSURE TRAPPED
IN THE HYDRAULIC SYSTEM
To avoid personal injury:
A To relieve the residual pressure, do it
immediately after the engine has stopped.
1. Lower the attachments and the blade down to the
ground.
2. Turn the key to "STOP" position and shut off the
engine.
3. After stopping the engine, turn the key to "RUN"
position.
4. Set the lock lever to "Unlock" position.
5. Move the operating lever to release pressure in the
hydraulic system.
[How to release pressure trapped in the AUX port]
1. Perform the above operations of 1 to 4.
2. Turn "ON" the AUX port enable switch.
(A) Warning
(B) Indicator
(C) Switch 5
(D) Switch 3
(1) Lock lever for attachment control
(2) Attachment control lever (left)
(A) "Unlock"
(B) "Lock"
(1) AUX port enable switch (Switch 3)
To Next Page
Loading...
