INTELLIPANEL(TM) CONTROL52
C Setting the traveling speed gear in the field mode
Touch the field mode setting switch (5) in the above figure,
and the "field mode" traveling speed gear setting screen
shows up.
1. Referring to the traveling speed chart, determine
maximum and minimum main gear shifts that are best
suited for the job in question.
2. Setting the maximum main gear shift
Using the high-speed setting switch (4), preset the
desired traveling speed. (The high-speed slider moves
to the set position.)
3. Setting the minimum main gear shift
Using the low-speed setting switch (3), preset the
desired traveling speed. (The low-speed slider moves
to the set position.)
4. The automatic gear shift is carried on within the
displayed main gear shifts (1).
5. Touch the switch (2), and the setting is completed and
the previous screen reappears.
C Setting the auto shift sensitivity
[When operating in the auto shift mode]
With the auto shift sensitivity control (1), the engine rpm for automatic gear shift up/down can be preset.
Make readjustments according to the job in question for eco-friendly operation.
[When operating in the manual operation of the road mode]
Suppose that the sensitivity level has been preset with the auto shift sensitivity control (1). If the ez-command center is
used for gear shift over the range gear shift (from A to F) in such a case, the selected main gear shift works in a different
way.
C Setting the engine rev-limit
1. Touch the target top engine rpm point on the engine rev-limiter control graph (2), and the slider will move to the touched
point.
2. With the "Plus (+)" or "Minus (-)" switch (5 or 6), finely adjust the rev-limit.
3. When the point is set at MAX, the rev-limiter control is cancelled.
(1) Selected traveling speed gear shift
(2) Previous screen resume switch
(3) Low-speed setting switch
(4) High-speed setting switch
(5) High-speed slider
(6) Low-speed slider
(7) Main gear shift range
Operating Auto shift sensitivity control Remarks
Eco-friendly operation with
traveling speed priority
A Retract the graph leftward with the
"Minus (-)" switch.
Suited for light-duty work.
Operation with PTO shaft
speed priority
A Extend the graph rightward with the "Plus
(+)" switch.
Suited for heavy-duty work such as
harvesting.
Operating Auto shift sensitivity control Remarks
Light-duty
A Retract the graph leftward with the
"Minus (-)" switch.
Shifted to the rev-up/slow-down levels by
skipping the traveling speed range.
Heavy-duty
A Extend the graph rightward with the "Plus
(+)" switch.
Rev-up or slowed down close to the current
traveling speed.
To Next Page
