FC302G - FC302GI - FC352G
14
4. - Safety
KN270BGB_F
Mower conditioner
Before attaching or removing a PTO shaft, or before
doing any work on the machine, disengage the PTO
drive, turn off the engine, remove ignition key and
wait for all moving parts to come to a complete stop.
If the primary PTO shaft is equipped with a torque
limiter or a free wheel, these must be fitted on the
machine side.
Ensure that the PTO shaft is always correctly fitted
and locked into place.
Before connecting the PTO shaft, ensure that the
PTO speed (rotational frequency) and direction of
rotation are in line with the machine manufacturer's
recommendations.
Before engaging the PTO drive, make sure that
there are no people or animals near the machine.
Never engage the PTO drive when the tractor
engine is stopped.
Do not install any adapter device that results in a
portion of the tractor PTO stub, the rotating PTO
shaft, or the adapter to be unguarded. The tractor
master shield shall overlap the end of the splined
shaft and the added adaptor device as outlined in
the table.
PTO type Diameter X splines A ±5 mm (0.20’’)
1 35 mm (1.378’’) 6 85 mm (3.35’’)
2 36 mm (1.417’’) 8 85 mm (3.35’’)
3 35 mm (1.378’’) 21 85 mm (3.35’’)
4 45 mm (1.772’’) 20 100 mm (4.00’’)
5 44 mm (1.732’’) 6 100 mm (4.00’’)
To Next Page
