KUHN FC302G - Page 57

8. - Instructions for work
FC302G - FC302GI - FC352G
57
KN270BGB_F
Mower conditioner
- Remove the 4 V-belts (1).
- Remove bolts and washers (2).
- Exchange pulleys.
1
2
2
Handle pulleys with care.
Pulleys must slide on their respective shafts
without effort. If this is not the case, clean
and coat the mating surfaces with grease
before sliding the pulleys on their shafts.
- Reinstall bolts and washers without tightening
them.
- Reinstall belts on pulleys.
- Reinstall belt tensioning bolt and washer on its
support.
- Tighten the tensioning bolt.
- Tighten pulley bolts using box spanner.
• Torque setting: 8.5 daN.m (63 lbf ft).
- Reinstall the belt guard (2).
- Replace side guard (1).
If the leaves are damaged and the stalks
crushed, reduce the rotor speed.
2
1