KUHN FC302G - Page 82

104 pages

Save Page as PDF

To Next Page

To Previous Page

FC302G - FC302GI - FC352G

10. - Maintenance and storage

KN270BGB_F

Mower conditioner

- Link rods.

- Wheel arms.

Main Page

Dear Owner3
Table of Contents4
Contents4
Identification of the Machine7
Front View7
Model Identification Plate7
Optional Equipment9
Safety10
Description of Symbols Used in this Document10
Safety Instructions11
Introduction11
Read and Follow the Safety Instructions11
Safety Decals12
Precautions to be Taken before Carrying out any Operations on the Machine12
Precautions When Coupling12
PTO Shaft13
Hydraulic Circuit15
Remote Controlled Components16
Precautions When Driving16
Precautions When Driving on Public Roads16
Maximum Speed18
Tyres18
Precautions to Take before Using the Machine18
Precautions During Manoeuvres19
Precautions for Machine Use19
Projection of Stones and Foreign Objects19
Precautions to Take before Using the Parking Stands20
Precautions for Maintenance and Repair Work20
Waste Disposal21
Location and Description of Safety Decals on the Machine22
Location of Safety Decals22
Description of Safety Decals23
Road Safety Equipment and Recommendations25
Tyre Pressure26
Instructions Specific to France26
Instructions Specific to Italy27
Likely Critical Failures27
Incorrect Use of the Machine by the User27
Limit State Criteria28
Machine Specifications29
Description and Glossary29
Designated Use of the Machine29
Technical Specifications30
Designated Parameters30
Required Equipment31
Drawbar31
Sound Levels31
Putting into Service32
Description of Control Elements32
Coupling and Uncoupling32
Description of Coupling Elements32
Preparing the Tractor33
Preparing the Machine34
Coupling the Machine35
Hydraulic Connections36
Electrical Connections36
Primary PTO Shaft37
Intermediate PTO Shaft40
Adjusting the Machine42
Uncoupling the Machine43
Instructions for Transport45
Putting the Machine into Transport Position45
Conformity with the Road Regulations47
Machine Transport Using Transport Means47
Instructions for Work48
Putting the Machine into Work Position48
Adjustments in Working Position51
Cutting Height51
Reduced or Increased Ground Pressure54
Finger Conditioning Rotor Speed55
Belt Tension58
Conditioning Intensity59
Swathing System61
Machine Use64
Drive Speed64
Optional Equipment65
Chain Stroke Limiter65
Mechanical Drawbar Shift65
Hydraulic Drawbar Pivot Control66
Ribbed Knife (FC302G - FC352G)66
Lifter Disks67
Quick Hitch67
Intermediate PTO Transmission Shaft with Constant Velocity Joint68
Lubrication68
Swath Shield Extensions69
Wide Spreading Shield (FC352G)69
SMV Sign70
Outline Marker Lights70
Maintenance and Storage71
Frequency Chart71
Lubrication72
PTO Shaft73
Draining75
Grease80
Maintenance84
Belts84
Checking Cutterbar Oil Level85
Checking the Oil Levels87
Inspection of Knives and Securing Elements88
Finger Replacement92
Storage93
At the End of each Season93
At the Start of each Season94
Storage94
Dismantling and Scrapping of the Machine95
Troubleshooting Guide96
Limited Warranty99

KUHN FC302G - Page 82

Table of Contents

Related product manuals