GMD24-GMD28 / HD
46
6. - Putting into service
KN226BGB_A
Disc mower
- Press push-button (1) and lower parking stand (2)
until push-button engages in position (3).
- Lower the tractor three-point linkage to rest the
machine on the ground.
- Detach the top link from the machine end.
- Uncouple the PTO shaft.
- Support PTO shaft with check chain attached
around the hitch pin.
- Disconnect hydraulic hose from tractor.
- Remove cord from tractor and store it in its holder
on the machine.
- Release the lower links.
- Lower the tractor three-point linkage.
The machine is uncoupled.
To Next Page
Loading...
