GMD24-GMD28 / HD
50
8. - Instructions for work
KN226BGB_A
Disc mower
8. Instructions for work
8.1 Putting the machine into work
position
From the transport position:
- Lift the machine with the tractor's three point
linkage.
- Remove lynch pin (1) and pin (2).
- Put compensation system in working position
using pin (2) and lynch pin (1).
- Activate single acting valve of transport/work
positioning cylinder to lighten pressure on
transport lock.
- Pull the release cord until transport lock is
released.
- Place the single acting valve of the mowing unit lift
cylinder in floating position to lower the mowing
unit.
Before placing the machine in working
position:
- Check that nobody is within the machine
pivoting area.
- If there is someone, make sure the person
moves away.
To Next Page
