Kurzweil PC4 SE - Controls Page

Multi Edit Mode
Controls Page
5-24
Controls Page
Use the Controls Page to adjust controller settings for each Zone. e PC4 SE has 2 types
of controllers, switch controllers and continuous controllers. Each type of controller has
dierent parameters, see each section below for details.
Controlling Program Parameters from Multi
Mode
To assign a Multi controller to a Program parameter, use the MIDI Dest eld. In the MIDI
Dest list, destinations that are assigned to parameters for the Program of the current Zone
will show the Program Parameter name next to the MIDI Dest number. Select one of these
destinations to control an assigned Program parameter.
You can also select the MIDI Dest eld, hold the ENTER button, then move the controller
that was assigned in Program Mode.