Kurzweil PC4 SE - MIDI CC Step Sequencer Page

Program Edit Mode
MIDI CC Step Sequencer Page
3-27
MIDI CC Step Sequencer Page
e CC Sequencer allows you to rhythmically modulate up to 4 program parameters (such
as lter frequency) based on preset or user patterns. CC is short for continuous controller,
which is a type of MIDI message that can be used to control assigned parameters. e CC
Sequencer can aect both internal programs and external MIDI instruments.
CC Seq Preset
Use the CC Seq Preset parameter to recall factory or user created CC Sequencer settings. A
CC Seq Preset contains settings for all of the parameters on the CC Sequencer page (except
for the State parameter, which is stored with the Program/Multi). Scrolling through the CC
Seq Presets is an easy way to discover the dierent possibilities of the CC Sequencer, or to
nd a preset similar to what you want and continue to edit it from there.
You can save your current settings as a CC Seq Preset by pressing the FAVORITES 1 button.
If you select a dierent CC Seq Preset before saving your current CC Sequencer settings,
the current CC Sequencer settings will be replaced by the settings from the preset without
showing a warning. Be sure to save your settings as a CC Seq Preset if you want to be able to
recall them after making additional changes. Even if you don’t save the current CC Sequencer
settings as a CC Seq Preset, the most recent settings will always be saved with the Program or
Multi when the Program or Multi is saved. Changing any of the CC Sequencer parameters
will change the Preset to “0 Edited CC Seq”, to indicate that the previous preset settings are
no longer being used.