Kurzweil PC4 SE - Common Page

Program Edit Mode
Common Page
3-7
Common Page
Use the Common Page to control overall settings of the current Program.
BendRange Up & BendRange Down
Use these parameters to dene how much the pitch will change when you move the Pitch
Wheel. Pitch values are set in cents, where 100 cents = 1 half-step (1 semitone).
For both Bend parameters, positive values will cause the pitch to bend up, while negative
values will cause the pitch to bend down. Large positive values can cause samples to bend
to their maximum upward pitch before the Pitch Wheel is fully up (or down). is will not
happen when bending the pitch down.
Output Gain
Use the Output Gain parameter to cut or boost the nal gain stage of the post-FX program
signal. is is useful for adjusting the overall volume of a program.
Category
is parameter sets the category that the program will be grouped into when you press one of
the Category buttons from the Program mode main page.