Song Mode
Track Functions Page
7-24
Track Functions Page
Use the Track Functions page to perform track-based edit functions such as Erase, Copy,
Bounce, Insert, Delete, Quantize, Shift, Transpose, Grab, Change, and Remap.
For each function, there is a set of parameters to control how the function operates, and on
what region of the selected track(s). e top right corner of the page displays the selected
track or tracks. Use the BANK -/+ buttons to select the desired Track(s).
Below is an example of the Track page for the Bounce function.
Use the parameters on the right side of the page to select the range of time and the type of
events that you wish to edit. Dierent event parameters may be available for each function.
For example, Quantize and Transpose apply only to notes, while Remap applies only to
Controllers.
e Locate parameter is always positioned on the bottom left of the page.
Note: Before using any of the track functions, it is a good idea to save your song if you have
previously made any unsaved changes that you would like to keep. After applying a track
function, there is no way to undo the changes, but if you have a previously saved version of
the song, you can revert to the previously saved version by selecting another song, pressing
the EXIT button when asked to save changes, then selecting the desired song again.
Once you’ve chosen a function and set the parameters to your liking, press the ENTER
button. is executes the editing function. You can then play the song to hear the results of
your edit. If you don’t like your edit, select another song and press the EXIT button when
you are asked if you want to save (you will lose any other unsaved changes that you have
made). If you do like the changes you have made, press the SAVE button and save the song.
To Next Page
Loading...
