Kurzweil PC4 SE - Page 114

Multi Edit Mode
Controls Page
5-26
MIDI Dest
Use the MIDI Dest eld to select a parameter to control.
Destinations 0-127 are MIDI continuous controller messages (CC numbers), which can be
used to control PC4 SE Program parameters, or external MIDI gear.
CC numbers that are assigned to Program parameters will show the parameter name next to
the CC number. ese CC numbers will control the Program in the current Zone.
Destinations 128 and greater can be used to control PC4 SE Program and Multi functions.
For details see “Controller Destination List” on page 5-31.
Note: When Controller is set to ArpOn/O or ArpLatch, the MIDI Dest parameter can
only be set to Arp On/O or Latch destinations.
On
e On eld determines the “On Value”, the MIDI value sent when a switch controller is set
to On. You can set this parameter to any number between 0 and 127, or to None.
Off
e O eld determines the “O Value”, the MIDI value sent when a switch controller is set
to O. You can set this parameter to any number between 0 and 127, or to None.
Entry
e Entry parameter determines the state of a switch controller when the current Multi is
loaded. You can set this parameter to None, On, or O. is parameter aects the selected
switch controller for all Zones.
If Entry is set to None, then when you load the current Multi, the switch controller state will
not change.
Exit
e Exit parameter determines the state of a switch controller when the current Multi is
exited by selecting another Multi or Program. You can set this parameter to None, On, or
O. is parameter aects the selected switch controller for all Zones.
Exit should typically be set to a value of “None”, which sends no message. Setting Exit to On
or O can be useful for advanced MIDI congurations and when controlling external MIDI
instruments or software.