Kurzweil PC4 SE - Page 171

Song Mode
Misc Page
7-15
Quantize
e Quantize parameter determines the amount of real-time quantization (if any) applied to
the sequence during recording. e percentage specied for this parameter is the amount of
quantization the sequencer applies to the grid (see below) for each Note event recorded.
Note that using real-time quantization has the same eect as recording normally, and then
using the Quantize Track Editing operation.
Grid
e grid parameter determines the resolution of quantization and the position of the grid
points.
Swing
e Swing parameter determines the amount (in units of percent) of “swing” applied during
quantization.
Release
e Release parameter determines whether or not note-o events are quantized.
Metronome Parameters
Metronome
is parameter determines the recording modes in which the metronome plays. With
Metronome set to O, the metronome never plays. With Metronome set to Rec, the
metronome only plays during recording. With Metronome set to Always, the metronome
plays during playback and recording. With Metronome set to CountO, the metronome
plays only during count o (if the CountO parameter is set to something other than O).
Count Off
is parameter determines the number of measures the PC4 SE will count o before
recording. With Start Only selected, the PC4 SE will only count o at the beginning of a
sequence. With Always selected, the PC4 SE will count o from any point in a sequence.
Program
is parameter determines the program with which the metronome is played.