Kurzweil PC4 SE - Page 21

Getting Started
PC4 SE Sounds
1-14
Selecting Multis
In Multi Mode, use any of the methods below to select a Multi.
Browse All Multis
Make sure the USER button is o, then use the ALPHA WHEEL or NAVIGATION
buttons to select a Multi from all of the available Multis.
Select a Multi by ID Number
e KEYPAD button allows you to use the numbers labeled on the CATEGORY buttons to
select Multis by ID number. Use the CATEGORY buttons to type an ID number followed
by pressing the ENTER button. Multis are not organized by category, so the KEYPAD
button is always on in Multi Mode.
Select a Previously Saved User Multi
Press and turn on the USER button, then use the ALPHA WHEEL or NAVIGATION
buttons to browse only User Multis. To return to browsing Factory and User Multis, press
and turn o the USER button.
Controllers
e Knobs, Sliders, Buttons, Wheels, and Pedals can control each of the Factory Programs
and Multis, to produce variations to the sound. Don’t forget to try these out as you explore
the Factory sounds on the PC4 SE.
Generally, each control will perform the assignment labeled on the front panel, although
some controls may have dierent assignments per Program or Multi. When a controller is
moved, the name of the current assignment is shown in the display. Controller assignments
can be adjusted in Program and Multi Edit Mode.