Program Mode
SPLIT and LAYER Buttons
2-10
3. On the Split Page, Zone 2 is selected with a default Bass Program selected for the left
hand of the Split. Use the ALPHA WHEEL or CATEGORY buttons to select a dierent
Program for the left hand of the Split.
4. You may wish to adjust additional Split parameters, described in Split and Layer
Parameters on page 2-11. Use the NAVIGATION buttons to select each parameter, and
the ALPHA WHEEL or CATEGORY buttons to change the value of each parameter.
5. Press the SAVE button to save your Split as a Multi (See below for details on saving).
After saving your Split Multi, you can edit additional Multi parameters in Multi Edit
mode.
LAYER
When you create a Layer in Program Mode, you are creating a Multi with two Zones set to
On.
e Program you were using in Program Mode is used for the Zone 1 Program. You can
choose a Program that will be used as the layered Zone 2 Program.
Follow these steps to create a Layer:
1. In Program Mode, select a Program that you wish to layer.
2. Press the LAYER button to access the Layer Page.
3. On the Layer Page, Zone 2 is selected with a default layer Program selected for the
layered Zone 2 Program. Use the ALPHA WHEEL or CATEGORY buttons to select a
dierent Program for the layered Zone 2 Program.
4. You may wish to adjust additional Layer parameters, described in Split and Layer
Parameters on page 2-11. Use the NAVIGATION buttons to select each parameter, and
the ALPHA WHEEL or CATEGORY buttons to change the value of each parameter.
5. Press the SAVE button to save your Layer as a Multi (See below for details on saving).
After saving your Layer Multi, you can edit additional Multi parameters in Multi Edit
mode.
To Next Page
Loading...
