Kurzweil PC4 SE - Page 54

Program Edit Mode
Common Page
3-11
Common Page KB3 Parameters
e following parameters appear on the Common page for KB3 Organ programs.
Leakage
is parameter controls the level of the simulated crosstalk and signal “bleed” of adjacent
tone wheels in the model. is is provided to help “dirty up” the sound to make it a bit more
realistic. A setting of -96 dB gives the purest tones; other values add more simulated leakage.
is level is scaled by the drawbar levels, as well as the expression pedal level.
LeakMode
is parameter selects between dierent leakage models, determining which leakage
harmonics are emphasized. TypeA provides an overall tone wheel leakage, with all tone
wheels leaking a small amount. TypeX, TypeY, TypeZ, and TypeR emulate dierent degrees
of drawbar leakage, where the leakage components correspond to the nine drawbars, instead
of all the tone wheels.
Chorus/Vib On/Off
Use this parameter to turn Chorus or Vibrato On or O. is is the same as setting the
Chorus/Vibrato On/O parameter on the Parameters page to 0 or 127. Use the Chorus/Vib
Cntrl parameter to select between Chorus or Vibrato.
Chorus/Vib Cntrl
Use this parameter to select Chorus or Vibrato, and select from 3 depths for each eect. is
is an easy way to select between the six possible Chorus or Vibrato settings by adjusting a
single parameter. is parameter functions the same as setting the Chorus/Vibrato Depth
parameter on the Parameters page to 0, 64 or 127, and setting the Chorus/Vibrato Select
parameter on the Parameters page to 0 or 127.