Kurzweil PC4 SE - Page 79

Multi Mode
Controllers
4-5
MODULATION WHEEL
In Factory Multis, the MODULATION WHEEL will typically control vibrato or an eect
amount. e name and value of the current assignment for each Zone/MIDI Channel is
shown in the Display when the wheel is moved. e assignment can be adjusted for each
Zone in Multi Edit Mode.
VARIATION Button
In Factory Multis, the VARIATION button will typically enable an additional layer or eect
for the Program in some Zones. e name of the current assignment for each Zone/MIDI
Channel is shown in the Display when the button is pressed. e VARIATION button can
be enabled or disabled for each Zone in Multi Edit Mode.
ARPEGGIATOR Section
ARP and LATCH Buttons
Press the ARP button to turn the Arpeggiator On or O. When the Arpeggiator is On, the
ARP button lights up.
e Arpeggiator allows you to easily play arpeggios or note sequences by holding down a
chord or a single note. Each Multi Zone can be saved with dierent arpeggiator settings. For
details on the Arpeggiator, see Arpeggiator, CC Seq and Riff Page on page 5-13.
With certain arpeggiator settings, pressing the LATCH button allows the arpeggiator to
continue playing after notes are released on the keyboard.
CC SEQ Button
Press the CC SEQ button to turn the CC Sequencer On or O. When the CC Sequencer is
On, the CC SEQ button lights up.
e CC Sequencer allows you to rhythmically modulate up to 4 Program parameters (such
as lter frequency) based on preset or user patterns. For details on the CC Sequencer, see
Arpeggiator, CC Seq and Riff Page on page 5-13.
TAP TEMPO Button
Use the TAP TEMPO Button to set the tempo of the current Multi. e Multi tempo
typically sets the tempo of the Arpeggiator, ris, and the rate of tempo synced FX (such as
Delay). To set the tempo press the TAP TEMPO button a few times at the desired rate.