Multi Mode
SPLIT and LAYER Buttons
4-8
4. You may wish to adjust additional Split parameters, described in Split and Layer
Parameters on page 2-9. Use the NAVIGATION buttons to select each parameter, and
the ALPHA WHEEL or CATEGORY buttons to change the value of each parameter.
5. Press the SAVE button to save your Split as a Multi (See below for details on saving).
After saving your Split Multi, you can edit additional Multi parameters in Multi Edit
mode.
LAYER
When you create a Layer in Multi Mode, you are activating a new Zone in the current Multi.
You can choose a Program that will be used as the new layered Zone.
Follow these steps to create a Layer:
1. In Multi Mode, select a Multi.
2. Press the LAYER button.
3. On the “Layer” Page, the new Zone is selected with a default layer Program selected. Use
the ALPHA WHEEL or CATEGORY buttons to select a dierent Program for the new
layered Zone.
4. You may wish to adjust additional Layer parameters, described in Split and Layer
Parameters on page 2-9. Use the NAVIGATION buttons to select each parameter, and
the ALPHA WHEEL or CATEGORY buttons to change the value of each parameter.
5. Press the SAVE button to save your Layer as a Multi (See below for details on saving).
After saving your Layer Multi, you can edit additional Multi parameters in Multi Edit
mode.
To Next Page
Loading...
