13. BRAKE SYSTEM
13-14
Mongoose/KXR 250
Remove the screw and remove the fluid
inlet duct.
Check the O-ring for wear or damage and
replace if necessary.
Remove the two nuts and remove the seal
boot.
Remove the circlip and then pull out the
push rod, washer, piston and spring.
INSPECTION
Check the cylinder inside wall, and spring
for scratch, corrosion or other abnormal
condition.
If any abnormal condition is found, replace
the inner parts or master cylinder.
Before assembly, inspect the lst and 2nd
rubber cups for wear.
Fluid Inlet Duc
To Next Page
Loading...
