3. INSPECTION/ADJUSTMENT
3-9
Mongoose/KXR 250
ENGINE OIL
OIL LEVEL
Place the machine on a level place.
Warm up the engine for several minutes and
stop it.
Check the oil level through the inspection
window.
The oil level should be between the
maximum (H) and minimum (L) marks. If
the level is low, add oil to raise it to the
proper level.
ENGINE OIL REPLACEMENT
Place the machine on a level place.
Warm up the engine for several minutes and
stop it.
Place a container under the engine.
Remove the oil fill cap and drain plug to
drain the oil.
Reinstall the drain plug and tighten the
drain plug to specification.
Torque: 2.0～3.0kgf-m
Fill the engine with oil and install the oil fill
cap.
Oil Capacity: At disassembly: 1.6L
At change: 1.4L
Inspection Window
Lower Level
Upper Level
Run the engine for 2～3 minutes and
check the oil level after the engine is
stopped for 2～3 minutes.
＊
Oil Fill Cap
Drain Plu
To Next Page
Loading...
