3. INSPECTION/ADJUSTMENT
3-10
Mongoose/KXR 250
ENGINE OIL REPLACEMENT AND
OIL FILTER CLEANING
Place the machine on a level place.
Warm up the engine for several minutes and
stop it.
Place a container under the engine.
Remove the oil fill cap and oil filter cap to
drain the oil.
Clean the oil strainer with solvent.
Inspect the O-ring and replace if damaged.
Reinstall the O-ring, oil strainer,
compression spring and oil filter cap.
Tighten the oil filter cap to specification.
Torque: 1.0～2.0kgf-m
Fill the engine with oil and install the oil fill
cap.
Oil Capacity: At disassembly: 1.6L
At change: 1.4L
TRANSMISSION OIL
REPLACEMENT
Place the machine on a level place.
Place a container under the engine.
Remove the oil filler bolt and drain plug to
drain the oil.
Reinstall the drain plug and tighten to
specification.
Torque: 2.0～3.0kgf-m
Fill the engine with oil and install the oil
filler bolt.
Oil Capacity: At disassembly: 400cc
At change: 300cc
Start the engine and warm up for a few
minutes. While warming up, check for oil
leakage. If oil leakage is found, stop the
engine immediately and check for the cause.
Oil Filter Ca
To Next Page
Loading...
